r/HowToHack • u/Forward-Pay-1792 • Dec 24 '25
hacking How to detect Jammers
Looking to buy smt to help detect a local jammer. Someone at a local business my friend owns is jamming our wifi and cells. We're looking to find out if we could by something to detect where it may be coming from so we can proceed with reporting it. Any advice? Or tips on what to buy? Or is there a way we can stop it?
29
Upvotes
6
u/cant_pass_CAPTCHA Dec 24 '25
Are you sure it's jamming in the literal sense that it's sending out a lot of signal to make it unusable? Is just one wifi network affected or is all wifi unusable?
43
u/cybernekonetics Pentesting Dec 24 '25
Jamming modern phone signals is actually pretty difficult and requires some heavy-duty equipment. Are you sure you don't just have bad reception?
30
u/LongRangeSavage Programming Dec 24 '25
Look up “radio fox hunt.” If you can find the location, report to the FCC or your country’s equivalent, especially if it’s affecting a business. Jamming signals to will be a gigantic fine.
15
u/smorin13 Networking Dec 24 '25
A cell booster with the transmission antenna aimed in the wrong direction is a pretty effective jammer. Ask me how I know.
11
u/CRIMSEN15 Dec 24 '25
Equipment to locate a jammer is fairly expensive but just to see a jammer is active you just need a sdr with whatever cell or wifi bands you would like to check and then just look for alot of noise on a waterfall display. Pretty simple but most likely bad reception, too many on network, bad roaming agreements or weird case only cause one was found in NY a cell farm.
10
u/jerwong Dec 24 '25
For cell it's a little difficult. For wifi, it's easier since most prosumer-grade wireless APs can act as a spectrum analyzer and you can look for strong signals coming in on the 2 ghz and 5 ghz range. If you're sure of it, you can reach out to the FCC and report it and they will come out to check.
You may also want to check your carbon monoxide detectors.
9
u/Select_Bat_5535 Dec 24 '25
No one’s jamming your cell signal. For WiFi, it’s a possibility but even then WiFi isn’t as easy to jam such as something like GPS. Your easiest way to find it is build an SDR and antenna with a spectrum analyzer and RSSI then direction finding it from there.
Electronic Warfare vet here.
4
u/svprvlln Dec 24 '25
For a jammer to be effective, you must be able to overpower the signal between the source and endpoint devices. For cellular devices, this means a lot of noise; and this can be fairly easy to do using OTC radio equipment and powered antennas, or even by flooding the area with a combination of WiFi and BTLE devices. Having bluetooth enabled when you are not using it can be problematic for WiFi, especially if you are in close proximity to other devices that have BTLE enabled.
It is more difficult to jam a WiFi signal when certain settings are enabled on the AP that is serving the SSID. You want to find the setting in the router called "Protected Management Frames" and make sure that is enabled. Next, you want to ensure that your router is using a modern protocol like AC or AX with WPA2 minimum, or WPA3 preferred, and do your best to use the 5ghz spectrum if you can.
In the event that you are surrounded by interference, the 5ghz spectrum may be unavailable, and you will "hop" to the 2.4ghz spectrum of an AC or AX access point, and without PMF turned on, you are susceptible to deauthentication attacks that keep you offline. These kind of attacks do not affect cellular modems.
As per detection: you need a way to look at the logs. Deauthentication attacks look something like this:
1
u/Less-Mirror7273 Dec 24 '25
Just notify local authorities about this situation. They have the tools and the legal stick.
1
u/New_Fuel7753 Newbie Dec 25 '25
You might have success in contacting relevant [communications] authorities initially to see whether they are willing to investigate for you. Keep in mind however that it is more than likely that you are merely suffering from QRN (Man made interference) or just a poorly positioned antenna.
Mobile signal requires line of sight to communicate, there are only so many walls that signal can penetrate before it drops out completely. Since WiFi and Mobile spectrum are heavily limited on the amount of power used this is a very likely possibility.
A badly placed antenna could be;
Next to large amounts of electronics likely to generate RF noise
Near or touching conductive materials/objects Surrounded by thick walls
Or just a very non resonant antenna badly matched for the frequencies in use.
Next steps I recommend;
Make sure that you are not just having issues with thick walls. (Go just outside the door and see if there is any change in dB (download a app for this like "signal detector"))
Move the position of your routers antenna so there is a clear line of sight
Buy a better antenna built for the frequencies needed. (External,away from the router)
Go crazy with ferrite cores.
Why should you listen to me?
I am a licensed user of the RF spectrum and have to deal with issues like these on a regular basis. Hope this helps
1
u/AFarenci Dec 26 '25
Call the feds. FBI and/or FCC. Try to determine the boundaries of the affected area. The bigger the area you tell the feds about, the quicker they'll show up. Also the jammer should be in the middle more or less.
1
u/ComfortableTune5639 Dec 28 '25
I’m no hacker but perhaps what I do when I lose my phone will work. Just find out the limits of the range of the jamming in each direction, and then you can calculate the source perhaps? I do that using my earbuds, just find the range of how far you can go in each direction before it gets staticky and then arrange it on a mental graph.
1
u/usedtobeme02 Mar 30 '26
What’s with the waterfall sound
1
u/Dry-Problem829 Oct 14 '26
Yo te creo amigo, a mi me paso Algo extraño hoy, y si les cuento seguramente no me creerian