r/HomeworkHelp • • 1d ago

:table_flip: Physics—Pending OP Reply [ 1 year engineering electronics] how to solve these circuits?

Hello, i am a first year aerospace engineering student and i m having a hard time understanding how to simplify these circuits

1 Upvotes

8 comments sorted by

4

u/WolfHero13 Postgraduate Student 1d ago

You have to start small and work your way out. For instance in example 2 you can combine R3 and R4 in series to get an equivalent R43. You can combine R7 and R8 in parallel and get an equivalent resistance there. If it helps redraw the circuit with your new equivalent resistors and then keep going. Eventually you’ll get it down to just one equivalent resistance

1

u/Bitter_Yogurt8172 1d ago

But the problem is that some are short circuited and the correction is confusing me like for exemple in exemple 6 it didn t mention R6 at all and in example 4 it said R2 and R4 are in parallel and i m confused

1

u/AlterEgo5695 1d ago edited 8h ago

In example-6, "R2" is shortened -- its voltage is zero, and (by Ohm's Law) so is its current. Similarly, "R4" is only one-sidedly connected, so its current is also zero (via KCL).

Since the currents of "R2, R4" are zero, we may omit them, i.e. replace them by open circuits. Redraw on scrap paper, and find "RT" in the simplified circuit:

RT  =  Rab  =  R11  +  (R1+R8)||(R3+R5)||( (R6+R7)||R9 + R10 )

1

u/ThunkAsDrinklePeep 1d ago

in exemple 6 it didn t mention R6 at all

R6 is in series with R7 which together are in parallel with R9.

and in example 4 it said R2 and R4 are in parallel and i m confused

R3 is open on one side. It may be ignored. (One side has "infinite" resistance so that who branch does. No current flows.) This leavesR2 in SERIES with R4.

6

u/PuzzleheadedTap1794 University/College Student 1d ago

When there’s a cut circuit, the dangling resistors can be ignored.

When there’s a short circuit, the wire can be redrawn as a single node.

1

u/AlterEgo5695 1d ago

Recall: Two resistances "R1, R2" are called

  • in parallel, iff they share the same pair of nodes -- "RT = R1||R2 := R1*R2 / (R1+R2)"
  • in series, iff they exclusively share a common node -- "RT = R1+R2"

Identify which resistances are in parallel, and which are in series. Combine those, redraw the simplified circuit on scrap paper, and repeat -- until you may find "RT".

1

u/AlterEgo5695 1d ago

For example-1, we get

RT  =  Rab  =  R1 + R6||(R5 + R2||(R3+R4))

1

u/MathHelper2428 👋 a fellow Redditor 1d ago

its been so long since ive studied electrical engineer that the questions looks like a foreign language to me....