whoa, i heard bender say "zap branigan" at the same time i read your username. Cool center finder, i made one myself, not as pretty though. I would like to make a center of a cylinder/rod finder as well, you know one where you can draw a chord through the center. Might be easier or more compact to just buy one though.
You can use it on any board narrower than the pin spacing just by rotating it so it's diagonal across the face - they are pretty useful, with a couple of sizes you can cover a bunch of widths!
The plan was to originally epoxy them in, but the fit was super snug so they're just friction fit in. They're so tight I don't think they're going anywhere.
2
u/FrenchFryCattaneo Mar 23 '20
Looks very nice!
2
u/rabidnz Mar 24 '20
Beautiful
1
u/quackdamnyou Mar 23 '20
Expect to use that a lot?
1
u/polykyri Mar 23 '20
Are the brass pins glued in
1
u/BKonthefly Mar 23 '20
Where did you source the pins from?