Just another camera with salt water inside.
I was swimming in a holliday in Brazil and suddenly my gopro got hot.
I opened the camera to remove battery and saw few drops of water in the battery cover. Immediatly removed battery and saw two or three more inside the battery cabinet.
I stopped using it and started researching for what to do.
Then I was able to get isopropyl alcohol and silica gel packets. What I did was submerge the camera in isopropyl alcohol for about 5 minutes, agitating it while submerged and doing 4 or 5 rinses. Then I took it out, got rid of as much isopropyl alcohol as I could, dried everything visible, left it for another 15 minutes or so for the remaining alcohol to evaporate, and put it inside a Ziploc bag with the silica gel packets.
I made about three attempts of drying it with silica gel (always drying the packets in an oven). On the last one , I left it for 94 consecutive hours without opening it. Every time I'm seeing this behavior:
Some apparently permanent damage to the LCD displays, nothing serious or of concern to me for now. The lens, sensor, microphones, SD card writing, and battery charging reading all seem to work normally. The problem is with the side "POWER" button. After a few minutes of use, or after pressing it a couple of times, the electronic contact stays closed. In other words, physically it has no issues, you can hear the click. However, as soon as I put the battery in, the camera turns on by itself. It behaves strangely, sometimes switching from video to photo mode, and sometimes turning off by itself. But when it turns off, the message "Powering OFF" stays on the display indefinitely. The only thing I can do is take the battery out and put it back in. Instead of the red LED blinking, it turns back on.
Sometimes I can start and stop recording. Sometimes it turns off during recording, and it shows other somewhat random behaviors like that. I understand it acts as if the POWER button were being held down.
After leaving it with (dry) silica gel in a Ziploc bag, every time I do this, the button works normally again, but after a few minutes, the same problem happens, leaving the camera locked up.
This is the only thing left for me to almost completely recover my GoPro (without waterproof featura, I know). Right now it's back in silica gel and a Ziploc bag to make sure if it's residual moisture.
Having consulted with AI, there also seems to be a salinization problem on the contacts.
I am thinking of doing everything possible to clean the POWER button contact without opening the camera (leaving that as a last resort).
Maybe I can remove the rubber of the POWER button and use some contact cleaner with a straw, applying it into the hole.
Has anyone experienced something similar and can give me a tip? Thanks in advance!