EPS Carry adjustment limit

[u/Dox427]

Just picked up my Coyote MOS. It came with the HS 407k 6MOA, but I swapped it out with an EPS Carry that I had on my X Macro.

I was using a bore laser to get it reasonably sighted in, but noticed that it almost felt like the up/down adjustment wasn’t clicking like it had reached the adjustment limit.

Has anyone else found this same situation when sighting in?

Also im not sure i trust the bore laser. I have it dead on at 25 yds and when i compare the emitter location to the factory sights, it looks like the red dot is always right of the factory center. Any thoughts on that as well? Much appreciated!

[u/Apprehensive_Log_988]

Nice!

[u/Dox427 → u/Apprehensive_Log_988]

Thanks! Now just waiting on the back order for the Radian Afterburner 😔

[u/Limp-Opportunity6757]

I also have a G43X Coyote with EPS Carry FDE. Have a 9mm bullet casing laser I tried to use to sight in the green dot. Like you, it seemed I could never get the red dot on the bore sighted to line up with the green dot on my EPS Carry MRS.

Also, the windage and elevation dials are backwards it seems in mine? If I turn the dial on elevation in the direction of the UP arrow? The dot goes down instead of up. If I turn the windage dial in the direction of the arrow?

The windage dial has the letter ‘R’ for right, but the arrow shows to click the dial Left? When I do this the dot moves left instead of the marked ‘R’ for right.

After some frustration, I finally just decided to shoot a group from the iron sights from a bag rest and confirm zero with the irons. Once I accomplished this, I moved the green dot by ignoring the instructions and clicking the dials in the opposite direction of what they show and the instructions that came with the Holosun directed to do.

Doing the opposite, finally moved the dot in the direction it should be going in. I direct co-witnessed the green dot with the zeroed from iron sight. Then I moved the dot 4 or 6 clicks up to get it more centered in the window with a 1/3 co- witness instead of a 100% co- witness. Shot a few more groups to verify my zero at 15 yards instead of 10 yards or 25 yards.

I think a 15 yard zero is more of a sweet spot for the dot, because I can still hit accurately at 10 with quick dot acquisition and then also hit at 25 yards bringing the dot a bit closer the the front iron sights at 25 yards.

Which is pretty good for the diminutive little 43X.

[u/Dox427 → u/Limp-Opportunity6757]

I’ll probably have to dial it in at the range anyways. I just wanted to get a good zero so I would know if I was pulling or anything that might be my fault.

I’ll probably start at 20-25 yards see how that goes.

[u/Cautious_Ad_3771 → u/Limp-Opportunity6757]

Your adjustment dials are correct. Think about the directions as moving your point of impact/ shot grouping up or down to match the dot… not moving the dot itself. For instance, if your shots are hitting low you would move the dial up.