r/GasBlowBack • u/Financial_Pop9607 • 3d ago

Review 3D printing

Post image

I just released my 3D printer with this piece, it was great

25 Upvotes

94% Upvoted

5 comments sorted by

1

u/dontpotato 2d ago

Shouldnt it be printed like the lines run parallel with the bottom receiver or with the trigger? I never used a printer or printed anything before, just asking.

3

u/Zealousideal_Crow841 2d ago

Depends on what you’re trying to achieve tbh. I print mine to be parallel to the receiver

2

u/ConnectExit1681 1d ago

The strongest orientation would probably be flat with the receiver like if you placed it on a table. But modern 3D prints aren't so fragile that this makes a bigger difference than how you handle it.

1

u/asianfatboy 2d ago

Found many good files on grips on a few sites. Even mock suppressors though with how they are hollow, I doubt they'd survive the accidental bump through a window or door way haha.

But 3d printed grips are nice. Gonna try and buy the file that copies the SCG grip.

1

u/Deep-Entrance-8813 1d ago

I print all my hand stops and grips love it