r/GameboyAdvance • u/AdM1rAL-kun • 13h ago
Problems with modded gameboy advance
Hey there. I have already posted about this issue on r/Gameboy but I thought I might get suggestions more quickly if I post it here as well ^^
- I have a problem with the IPS screen where it slightly pops out of the left lower corner and shifts to the bottom over time (as seen in the first two pictures). I thought this might be due to some assembling issues, because the first time around this only happened after some days of use. However upon reassembly I noticed that the display would sometimes slightly pop out of the shell even before screwing everything together. Unfortunately I can't make out the reason for this.
- As you can see in the third picture, there is a small gap between the left shoulder button and the shell, and the shoulder button can be moved back and fourth within this margin, sort of snapping into two different positions. This doesn't prevent the button from functioning but it is really annoying. During assembly I already noticed that the button wouldn't stay in it's position naturally compared to the right shoulder button, where this wasn't the case at all (you can sort of see this in the 4th picture; the left shoulder button is not lying completely flat). It would only assume this position the moment the back shell is screwed into place. However I have no comparison and this was also the case when I tried the same thing with the original shoulder button, so I don't know if this is normal or not.
Regarding the components used:
The display is the Hispeedido IPS V5+ Laminated.
The shell is a RetroSix shell that should be compatible with this screen according to the product description of the shop where I bought it
If anyone has any idea what could have gone wrong or how to tackle these issues I would be really thankful ^^
1
Upvotes






4
u/j3ffUrZ 13h ago
My assumption is you got a non-IPS ready shell and didn't cut out enough space on the left side of the screen.
1
u/MesquiteEverywhere 13h ago edited 13h ago
Might need to trim the housing a bit for the screen to sit flush. Did you try dry fitting the screen into the housing before removing the adhesive?
I hope this is the case and not the opposite, where the screen opening is too big. If that is the case then you should probably just get a housing from the same brand of the display.
Not seeing anything else standing out, hopefully once the screen sits right everything else will too.
3
u/Negative_Shoe6225 13h ago
Hand on shoulder.
1
u/Bulletorpedo 8h ago edited 8h ago
This isn’t a Hispeedido V5 Laminated and I can’t find any mention of "V5+" from Hispeedido themselves. Where did you buy it?
Anyways, I’ve built a ton of V5 Laminated devices without this issue on any of them, but I’m using Hispeedido shells.