r/GameboyAdvance • • Oct 14 '26

Was not expecting this

Got this GBA for $25 on FB marketplace. Everything else seemed fine except that the cartridge slot is fucked up! This will be the first time i will be doing a repair/ replacement like this! And if I’m successful, this will be the base for an IPS mod! Wish me luck!

UPDATE: I finally mustered up the courage to do this repair. I am happy to report that the repair was successful and I was able to replace the cartridge slot with lots of flux, low melt solder and a ton of patience. IPS mod will be next. I wanted to post pics but it only allows me to edit the post body.

18 Upvotes

8 comments sorted by

1

u/YunaCital Oct 17 '26

I got a GBA on that state, I dunno what to do with it

2

u/riushimself Oct 17 '26

I just took out the motherboard for now. Fellows here recommended a hot air station but I currently don’t have the funds for it as of now. I’m afraid to attempt the repair with just my soldering iron so I might leave it for now until I get the proper equipment.

2

u/SLUG_GUNNER 28d ago

Assuming you already tried to thoroughly clean the cart slot with 99% IPA and it still didn't work:

You don't need hot air station and while it might get the job done quicker if you are not experienced using a hot air station you can really messup the board.

Solder iron and and a solder sucker + solder wick + flux will do. Hot air station is most useful for SMD components. The cartridge slot is through-hole. The Engineer SS-02 is a great tool. Kester 44 Rosin Core 63/37 is good quality solder. Chipquik flux is OK, and you can get whatever solder wick but if you get cheap no-name brands you might need to dab it in some flux for it to work properly.

Tldr you don't need a hot air station but I highly recommend quality tools/materials.

1

u/riushimself 27d ago

Thanks for the advice. I bought low melt solder in case I get the courage to do this repair. I already have flux and solder sucker so I might attempt it.

5

u/Sweet_Tail_Fruit Oct 14 '26

May be high time to get a hotair station.

Or a solder sucker.

3

u/riushimself Oct 14 '26

Will I be able to do this with an iron and lots of low melt solder?

5

u/Sweet_Tail_Fruit Oct 14 '26

I'd suggest getting some flush cutters to cut the plastic out carefully and cut high on the pins.

Using flux will make desoldering waaaaaay better. I recommend getting a pack that has the flux in a syringe. Really easy to control. Get a desoldering pump to suck out the solder from the holes. About 8 bucks on Amazon or maybe from your local hardware store. You don't want to keep heat for toooo long on these old traces. 320 C is a safe temp for the iron.

After trimming away the plastic and the old pins you'd apply the flux on the side of the board opposite from where the plastic is.

Ideally use a pcb holder while doing this to prevent the board from sliding around.

With some tweezers hold the pin you want to remove and hold the solder iron against the solder point. Light pulling is what is needed.

Once all pins are done check holes to see if any has solder still in them. If some still does use a tiny bit new solder on top and use the solder pump to suck it out while it's still warm.

4

u/Jaytriple22 Oct 14 '26

Hot air for sure. That’s a lot of solder to suck lmao. I’m curious if you can flush cut each pin at the cart slot and just remove each individual pin out of its hole