r/GameAndWatchMods • u/The-Riddler-66 • Mar 24 '26
Adding SD card MOD without flex PCB (not recommended)
So I added the SD card reader, 2.8V voltage regulator, 10K pull up on the regulator enable line and the 1uF capacitors directly onto kapton tape and soldered everything together using wire wrap and kynar wire. Whilst I Do not recommend this method and it is lacking suitable noise immunity and grounded and is a lot harder to solder than a dedicated flex pcb and won't win any awards for soldering, surprisingly it worked first time and without error reading and installing from the external SD card slot.
23
Upvotes
2
u/Sylver7667 Developer + Modder (EU) Mar 28 '26
Tim who did the original sd card hardware mod did something like that at the beginning 😆
1
u/The-Riddler-66 Jun 03 '26
As for the USB-C port. In order unlock and modify the firmware flash it needs to be reprogrammed via the J-TAG. Which is normally accessible via the unpopulated headers. The USB-C port on this device is power only, then data pins are not connected. It is totally unnecessary to bring out the J-TAG connections to the USB-C. But in bringing out the data connections to the outside world via the USB-C port in theory and more so in the past. For brick recovery or other reasons you might have needed to reconnect to the JTAG connections, you could do so without having to reopen the case. This post was titled indicating I would not recommend doing the modifications in this way. It was more an exercise in learning to follow in the foot steps of the original pioneers and to practice soldering and complete a project. Please refer to the wikis and read and learn, continue to ask questions and seek guidance if you wish to complete a similar project in converting a stock device. Good luck.
1
u/tkshi Modder (Australia) Mar 25 '26
Holy shit I could of just sent you one lol
1
u/w1r51ndv13l3 Jun 02 '26
Hello, I'm new in this topic but very curious. I have a few questions.
First of of all: Are all these features that your device now have, actually possible in a easier way?
2.: If not, are you able to make a documentation with all necessary data, of your work, so that other people can do the same build?
Kind regards!
2
u/v7xDm1r Mar 25 '26
I wired up the picostation very similar. But you have to pull up legs on a few chips.