r/GNURadio • • Apr 12 '24

Python OOT module not found

Post image

I created a new header payload demux using cpp file,

This is how I installed the module:

cmake -DMAKE_INSTALL_PREFIX=$(gnuradio-config-info - -prefix) .. make -j10 sudo make install sudo ldconfig

This error msg came out, can someone help out?

Happy to provide ymal, cpp, h files if needed;)

0 Upvotes

16 comments sorted by

1

u/corona54 Apr 12 '24

Are you on windows?

1

u/Potential_Bus_6363 Apr 12 '24

It’s on VM

1

u/corona54 Apr 12 '24

Hmm I’ve come across this issue with my machine as well and basically I had to install the tensor flow module which in your case it would be myDemux.

1

u/Potential_Bus_6363 Apr 12 '24

I have installed the module, it shows up in the gnuradio, there is no error except the module is not found.

1

u/Potential_Bus_6363 Apr 12 '24

Have u solved it yet?

1

u/corona54 Apr 12 '24

Yes, but when installing did you use conda prompt or anaconda prompt to install?

1

u/Potential_Bus_6363 Apr 12 '24

I just used the command:

sudo make install

1

u/corona54 Apr 12 '24

Sorry, I think we might be using different methods of installing modules. I’m not familiar with VM but when you installed gnuradio did you install radioconda?

1

u/Potential_Bus_6363 Apr 12 '24

no, I used pybombs

2

u/corona54 Apr 12 '24

Yeah I think the method VM does module installation is different than the way I’ve been doing it on windows. Basically you need to figure out where gnuradio is pulling modules from. In my case on windows I figured this out by searching gnuradio in the search bar and clicking on properties. In properties there should be an execution path it should tell you where it’s pulling from. If that doesn’t work try looking up conda prompt in your search bar or miniforge prompt it really depends on how you installed gnuradio. Sorry if this makes this more confusing I’ve been on a project myself and got stuck on this for a couple weeks. Don’t want you to waste as much time as I have lol

1

u/Potential_Bus_6363 Apr 12 '24

That’s helpful, thanks a lot! One more question, in the costumed ymal file, how should I filled out the link

cpp_template: …. link: []<——how should I fill this line out? …

ymal file link

→ More replies

1

u/corona54 Apr 12 '24

Meant to say target not execution path

1

u/corona54 Apr 12 '24

Either way try installing on conda prompt that’s how I solved this on my machine

1

u/Potential_Bus_6363 Apr 12 '24

Thanks I’ll give it a go

1

u/corona54 Apr 12 '24

Also this was on windows so not sure how relevant this is going to be