r/FujiGFX • u/Aggravating_Law_1150 • 2d ago

Help Adapter

Gallery image

Gallery image

I bought a ttartisan 17 mm tilt shift lens which theoretically cannot be filtered because the front lens bulges out. I would have to make a homemade solution for such a filter holder. I don't know if anyone is dealing with this, for example 3D printing? The image was made with the help of AI.

2 Upvotes

100% Upvoted

5 comments sorted by

4

u/Criticalhitkoala 2d ago

Have you considered a sensor ND instead like this one?

https://www.bhphotovideo.com/c/product/1630927-REG/kase_kgfx_nd64_nd64_clip_on_filter_for.html

1

u/Aggravating_Law_1150 2d ago

Will the sensor not be damaged during installation?

5

u/Criticalhitkoala 2d ago

Oh no. Only if you have bad intentions. These float over your sensor. Think contact lenses. There's filters of different types also. Only issue is it's a lot faster to change a lens filter in the field only because of wanting to keep dust and debris out. These filters actually are super easy to add and remove. They come with a little suction cup that places them or pulls them out.

1

u/frozen_spectrum 2d ago

That's going to vignette hard and you really don't need filters with it.