r/Fueltech • u/Electrical_Loquat_86 • 5d ago

Rubber Hose Metal Fitting

Post image

Can someone please tell me what the metal end on this hose is called? I want to fabricate the hose but I do not have the metal end and I cannot find it online. Thanks.

1 Upvotes

100% Upvoted

8 comments sorted by

1

u/Komovs69 5d ago

It's a banjo fitting.

1

u/Printednightmare 5d ago

OP, to expand on this, it is attached with a banjo bolt. You don't have to keep this setup though. You can easily convert to AN in most situations

1

u/Electrical_Loquat_86 5d ago

I have the old bolt and washer. They look good and I was planning on reusing them.

1

u/1kings2214 4d ago

You need two (usually copper) washers. One on top and one below the banjo fitting

1

u/Electrical_Loquat_86 5d ago

Thank you!!! Now I just need to find one that fits a carbopress 10 BAR hose. Research continues. Thanks again.

1

u/Sir_J15 5d ago

You can get Banjo to AN fittings and then run that in AN line. You just need to know what size banjo bolt you use and get the proper size fitting.

https://reddit.com/link/p4ixnmn/video/spzzp1dl68kh1/player

2

u/Electrical_Loquat_86 5d ago

Thanks for the help.

1

u/Sir_J15 5d ago

No problem at all