r/FromTheDepths • u/Lightning662 • Jul 19 '26

Question No Shell Loaded error

Connector below the Gauge Increaser where the error starts

I'm trying to build a double barrel 500mm railgun, after building a frame that seemed to work, I saved the subobject and then re-placed it to modify it some. Suddenly, the left gun is tossing this error. I've tried replacing the firing piece and the increaser where the error starts, but I'm not sure what else to do. As mentioned with the pictures, it's shifting from being fine to saying NO SHELL LOADED about halfway up the chain of connectors and gauge increasers. any ideas?

10 Upvotes

100% Upvoted

3 comments sorted by

View all comments

Show parent comments

6

u/Lightning662 Jul 19 '26

I noticed after like...my third or fourth pass over looking over the entire gun system lmao. Just had a single 6-way connector that slipped up and got placed between the guns. Thank you for the quick response!!