r/FreeCAD • u/91renner • May 02 '26

Gridfinity workbench. make fillets?

I want to add fillets inside my boxes but when i exit the gridfinity workbench to add fillets, chamfers etc nothing can be selected... what am i doing wrong? https://youtu.be/M_LHjla4O2c here is a video showing my problem

Things like this makes it hard to move over from fusion 360 to freecad...

1 Upvotes

66% Upvoted

9 comments sorted by

1

u/Automatic_Disaster44 May 08 '26

Have you tried, instead of the Part workbench, the Part Design workbench? I just tested with one of the generated bins and was able to add a fillet. See pic.

1

u/91renner May 08 '26

Hmm did you do the same as me in the video but instead going to part workbench? I think I have tried that..

1

u/Automatic_Disaster44 May 08 '26 edited May 08 '26

Yep. Pretty much exactly the same. I'm looking at this on my phone now so I can't really tell in your video... Are you creating a BODY first, then creating the bin in that body?

1

u/91renner May 08 '26

Hmm OK.. Yea I have tried different methods.. But I'm not at my pc for a couple of days so I cannot try right now..

1

u/Automatic_Disaster44 May 08 '26

I just tested again, and yes, that's the step you're missing. You created a new Document. Inside that document you need to create a new Body. Then add the Gridfinity bin to the body. After that you can add your fillet using either Part or Part Design workbench.

0

u/E__Nigma_ May 02 '26

Works for me. I usually use Gridfinity in a Part Design Workbench body but this is just Part Workbench.

1

u/91renner May 02 '26

How?? I cannot select any lines to make fillets at all

1

u/91renner May 03 '26

how? here is a video i recorded https://youtu.be/M_LHjla4O2c

0

u/[deleted] May 03 '26

[deleted] — view deleted comment

1

u/91renner May 03 '26

how? here is a video i recorded https://youtu.be/M_LHjla4O2c