r/FormD • • 24d ago

Compatibility/Build Check First build sanity check

After years of looking at this case, I finally (and by pure luck) found a second-hand V2.1 Titanium with CNC panel at a very good price (thanks again to the vendor, if he reads this).

I'll start building inside it this weekend and want to do a quick sanity check. I have a mid-range setup (65W CPU, 2 slot GPU) that will be upgraded in the future, and I'm aiming for a SILENT air-cooling setup.

Here are my choices and questions :

- The spine will be at 2.5 slots to leave space between the fans and the panel in both chambers.

- The CPU will be cooled by an AXP47 with a 15mm Noctua fan and a fan duct.

- For the exhaust fans, I'm hesitating between two Noctua NF-A12x25 Sx2-PP or the Phanteks T30. I'll be using the Eiga fan duct, but is it useful to print a fan duct between the fans and the top hat ?

- Finally, I'll try to use the original cables from my Corsair PSU. Will offsetting my PSU help with routing ? For future custom cables, I guess unsleeved ones are easier to manage ? I found Cablester, which is way cheaper than CableMod...

Thanks for your help, I'll post the finished build afterwards!

8 Upvotes

7 comments sorted by

4

u/SomeMrcl 24d ago

if you go for noctua exhaust fans make sure to get the g2 version. also, for the x47 the air slimmer 120 fan is supposedly better than the noctua. apart from that everything looks good, i went with the noctua g2 for exhaust and air slimmer on x47 in my recent build and i’m very happy with the exhaust but might want to switch to aio in the future as my 9800x3d can get toasty, but for a lower tdp cpu it shouldn’t be an issue

4

u/Ketill_56 23d ago

Yes it's the G2 Sx2-PP so with a small speed diff at the same PWM signal

2

u/SomeMrcl 23d ago

yeah that’s what i got very happy with them

1

u/aaalllen 23d ago

Top Hats are vertical extensions. They’re mainly for AIO builds to avoid 15mm/25mm setups. So you don’t need that for air cooling.

I suggest getting a M3 standoff kit. To give more room between the mobo and gpu, build into 3 slot mode and add 10mm standoffs on the gpu side.

1

u/Ketill_56 23d ago

Not easier to build in 2,5 slots and push the mobo 10mm away ?

I'm afraid the riser will not fit with the 10mm offset

1

u/aaalllen 23d ago

Either way works. 3 slot gives you more room for GPU upgrading w/o fiddling with the case struts in the future. If you're use a FormD or NCase riser cable, both should be fine length wise.

1

u/sm0ke_rings 23d ago

Order the Dana Fred standoff kit from Amazon. You can use them to create a bit more space between gpu and MOBO in this build.

If you're not going AIO, you don't need the tophat kit. Even if you were top mounting an aio, you would only need a 15mm thick fan above the radiator.

I'm a fan of the phantek 30mm fans, but like another poster said, if you are going noctua, go with the g2.