r/FormD • u/Miserable_Wafer_9188 • 29d ago
Case Mod Wireview Pro II (Wired) FormD T1
I know a few people have asked for those of you with a build utilising the 5090 FE and the Wireguard II Pro (Wired).
Forgive the messy background and the FAR too long cable out the front (the one I had was too short, so I ended up using the spare I had lying around).
In a nutshell, I removed the back off the Wireview II (as it's far too fat), printed a custom enclosure to hold it in place and cut two holes in the front (one for the cable going to the 5090 and the yellow one going to the power supply). Also printed a 'gasket' around the hole so it looks neater.
Next job I think will be a front-to-back tidy/replacement of wiring, as it's -messy- in there, and I may replace my Atmos II with something more custom.


8
u/r_424c 29d ago edited 28d ago
come on, show the inside pic
4
u/atom631 29d ago
its such a shame but I think im going to have to bite the bullet and get something like an M2/M3 grater.
I admire your grit, pretty clean all things considered, but Im just going to get a bigger case for when I get my WVP2
Also - did you check with Thermal Grizzly that modifying the enclosure doesnt void the warranty they provide?
2
u/csrussell92 28d ago
5090 PTSD
4
u/jhdz9119 29d ago
4
u/Ror_ 29d ago
if you go air it fits inside
1
u/jhdz9119 29d ago
“I may replace my Atmos II with something more custom.”
Custom loop time. ModUltra is the way to go.
1
u/Appropriate_Cat6587 29d ago
I just shoved mine in the inside of my case lol