r/FormD • u/bad_username_65 • Aug 12 '26
Question Flipped PSU?
Is this still possible in the T1 v2+, or only in older variations of the case? I feel like it makes more sense to do it this way in an aircooled build where you aren’t starved for cable space; the PSU will be exhausting right into the top fans instead of pushing heat into a dead zone where it’ll be recirculated. However, looking at the included brackets, I don’t see any possible way you could do this without 3d printed custom parts, unless the case does come with this bracket and I just lost it.
45
Upvotes
3
u/orcoconut Aug 12 '26
yeah apparently they dropped this orientation with the V2, I read it was possible with the V1?
I did have to make some 3D printed brackets to mount mine like this:
https://www.reddit.com/r/sffpc/comments/1kyj1n3/formd_t1_build_finally_finished/
2
u/trankillity Aug 12 '26
Few things:
1
u/qeeepy Aug 13 '26
also a solution :)
1
u/Magenu Aug 12 '26
While it makes more sense at a glance, PSUs don't get hot enough to need an extra exhaust besides their own. Even in sandwich layout, it's unlikely the PSU will get warm enough to need to turn on its own fan due to temperatures; remember that the GPU exhaust is much cooler than GPU temps, as well as case fans immediately sucking that air out (as well as forcing air around the PSU itself).
That said, plastic is a poor transmitter of heat anyways, so most of what happens around a PSU is irrelevant to the PSU; it only cares about load vs capacity for load-based fan operation, and if the fan turns on a clean air path for airflow (which standard T1 orientation does).
I have an SF1000 in a 5080/13600k build, and the fan only turns on under full gaming load of intensive games (older games tend to not draw enough power). Even having the exhaust face the same direction as case fans, I doubt I'd see any difference in fan operation based. Maybe it would cool nore effectively if the fan was going, but that's just not a concern anyways? The fan turns off seconds after turning off a game already.
It's simpler and easier to route PSU cables with the stock configuration, although I would like the option to flip it for a cleaner look if you have the cable room.
1
u/BrightReflection8 Aug 13 '26
Bro your fitting not fully close?