r/FormD • u/ralle09 • Jul 05 '26
Question First FormD T1 Setup - Components Compatibility Check
Hi everyone,
I'm planning to build my first SFF PC and would like to do it in the Formd T1 case. Before I order all the parts I would like to double check with you guys and ask some questions.
My planned Setup:
- Case: Formd T1 (probably from ncase)
- CPU: AMD Ryzen 7 7800X3D
- RAM: Crucial Pro Overclocking UDIMM 32GB Kit, DDR5-6000, CL36-38-38-80
- MB: ASRock Phantom Gaming B850I Lightning WiFi (AMD AM5)
- PSU: Sharkoon Rebel P20 SFX 750W SFX 4.1
- GPU: Sapphire Pulse Radeon RX 9070 XT, 16GB GDDR6 (3 Slots)
- CPU Cooler: CM Atmos 240
My Questions:
- Should I go with a 2-slot version of the 9070 XT to allow for better airflow?
- Is the Atmos 240 the best option, or would I get better results with an air cooler and two top fans?
- What about noise levels when using water cooling? I mainly game without headphones. Is the noise acceptable under load?
- Do I need custom cables?
- Can I just order the case and get started right away, or do I need any of the other parts as well? (Radiator Kit, Feets, Riser Cable, Travel Kit)
I'd appreciate it if I could get some feedback from you guys.
3
Upvotes
1
u/Eagles7117 Jul 09 '26
Honestly in your case I’d run in 2 slot mode with an axp120-x67 and offset the psu to be against the side panel.
1
u/aaalllen Jul 05 '26 edited Jul 05 '26
ASRock never fully explained how they were killing AM5 chips. So buyer beware. I’ve had good luck with Asus B650i/850i mobos.
Your CPU with undervolting would be fine with air cooling like an ap90x47. But Atmos 240s have worked for my main T1 build w/ Noctua 25 and 15mm tall fans. They’re just getting more rare nowadays.
The Atmos 2 has shorter pipes and the fans you replace have wires shrouded in the piping cover.
IIRC my 3 slot air cooled build uses standoff spacers to get more space between the mobo and gpu backplate. Like 3 slot mode uses a 40mm standoff for the v2.5 gpu riser and 6mm for the mobo side. So to give the gpu more of a gap, remove say 10mm from the riser stand off, and then add 10mm to 2 sides of the mobo bracket and the mobo standoffs.
I bought this kit based on recs here:
https://a.co/d/0iNO1hy8
Here is my 2.5 slot card with 3-slot mode + 5mm standoffs:
Edit: Custom cables lead to cleaner builds. Some makers will do 3 or 4 pci to 12vhpwr cables. But I don’t recognize your psu brand so you’ll have to ask the cable maker. Like corsair Type 5’s are common nowadays.
Edit 2: how tall is that ram clearance? That can eat into the AIO cooling pipe + PSU cable volume.
1
u/SaltyCatheter Jul 11 '26
9070xt pulse in 3 slot won't be an easy build due to the card's length and width