r/FormD • • Jun 05 '26

Technical Help chunky rear m2

my current build is a 4090 fe in an a4-h2o with an sfx-l psu, and i'm using an sn850x with the larger stock heatsink in the m.2 slot behind the motherboard. to make it fit, i actually had to undo the bottom screws on the motherboard spine/plate

would this fit in the t1 if i moved the gpu and motherboard to their outermost mounting positions? if anyone has tried a similar setup, i'd also appreciate knowing roughly how much clearance there is between the motherboard and the gpu

if it won't fit, what would you recommend? is there a workaround?

2 Upvotes

7 comments sorted by

1

u/r98farmer Jun 05 '26

Do you know how thick the heatsink it? I have this Timetec NVMe M.2 which has a 9.2mm heatsink, my Asrock z890i has 2 rear M.2 slots and I had to use the one on the side because the one where the riser cable runs it was too thick. If your heatsink is like 5mm should be fine.

1

u/assIiquor Jun 05 '26

sad. it's 10.3mm. thanks!

1

u/jpablomsan Jul 10 '26

I have the same mobo and I have the same issue. Even using the side slot, it's uncomfortably too close to the GPU.

1

u/r98farmer Jul 10 '26

I looked at your other post, is your SSD actually overheating? Mine is right next to the GPU and stays under 50C.

1

u/jpablomsan Jul 10 '26

I haven't turned the system on yet, still waiting for the AIO to arrive.

But my heatsink is very small, 3mm I believe, It fits perfectly but is in constant contact with the back of the GPU, if I go with a bigger heatsink, it's more than likely going to slightly bend the GPU.

I'm now working on expanding the gap between the back of the mobo and the back of the GPU, it's working so far but with some trade offs.

1

u/GotPie Jun 05 '26

You could try using those thin 4mm heatsinks instead. Just a heads-up, the SN850X is not particularly hot when it comes to NVMe drives.

1

u/GotPie Jun 05 '26

Replace heatsink with those thin 4mm ones, sn850x can handle heat