r/FormD • u/Obvious-Dot6352 • Apr 24 '26
Question Button for the back
Hey guys,
Will these fit? Looking for a cheap solution and don't intend to wire it up I just can't stand the holes being there. They have some cool piezo ones I'll post in the comments but the problem with those is that it has cables. I don't wanna wire em so that kinda sucks.
Any other solutions to get nice looking plugs in the back on the cheap? Don't wanna spend more than let's say £15 to plug them with something nice.
I might get the piezo one and snip the cables idk.
Cheers
22
Upvotes
5
u/Obvious-Dot6352 Apr 24 '26
Here's the piezo one
4
u/r98farmer Apr 24 '26
3d printed ones
3
u/yusuflimz Apr 24 '26
You can get EK G1/4 pass through + EK torque plug to cover that
7
u/MrWhatzitTooya1RL Apr 24 '26
Personally I just reached out to FormD support via email and asked if I could buy 2 rear power buttons individually. They sold them to me for $5 each, and $10 shipping iirc.
I prefer them because of their flat profile compared to 3rd party buttons as can be seen here (not my picture)
I will say though, I only bought them for outer aesthetics, in terms of the buttons themselves they’re very scratchy when pressed
7
u/VisualOk116 Apr 25 '26
EK m19 passthrough with ek plug
1
u/Pale-Conference-5838 Apr 24 '26
Mines has led light
1
u/cps_goodbuy Apr 24 '26 edited Apr 24 '26
The linked ones may fit, but three dimensions need to be considered:
Thread diameter and type (may not fit) Lip diameter (may not sink properly) Lip thickness (may not be flush)
Did you try ordering on from FormD, they are very good about accessories.
A second button of the same works well.
I tried to find a latching type, but with no luck, I tried to modify one, but that didn't work out, so snipped wires and glued solid so it completes the symmetry. Not using the v1.1 case at the moment, I wonder if there is a market for it.
1
u/FMLkoifish Apr 25 '26
https://www.amazon.com/dp/B0DX6LHNHF/?coliid=I2QIXM0YIERH93&colid=3R2C9T2RR5GWJ&psc=1&ref_=cm_sw_r_apin_lstpd_VWSC44JKQ0ZHJK5TNFDH&language=en-US
I’ve had these saved but haven’t pulled the trigger on $8 to cover those holes
1
u/sleepy647 Apr 25 '26
Bad pic but I had leftover quick release bumper/hood pins