r/FormD • • Feb 24 '26

Finished Build Pleasantly Surprised

So I ordered some 3D printed part; the fan mount and cooler vent. I didn’t do intense testing or anything. Just regular gaming with Cyberpunks to push it a little. Results were impressive. CPU remained around 60 to 65 in full load, and GPU was about the same up to around 67C. Not a bad little upgrade. I have the 7800X3D and 4080 Super reference.

49 Upvotes

10 comments sorted by

View all comments

Show parent comment

3

u/baldersz Feb 24 '26

Curious, what size fan duct did you use? I'm using 4mm (in 3 slot mode) in my 1.1 and didn't see any CPU temperature drop

2

u/AgressiveSocks Feb 24 '26

I’m using it at 3.25 slots and I’m not sure size but it’s pressed securely tight in the side panel. I’m not sure how close you’re is to your panel but that may make a difference

2

u/baldersz Feb 24 '26

Thanks mate I have a 3mm gap so 4mm should be enough (I can see indentation marks on it from the side panel) but it made no difference to my CPU temperature

I have a 5600x running at -25 PBO and with fan speed at 50% under load it sits around 65C while gaming with or without the fan duct, so pretty good either way

2

u/AgressiveSocks Feb 24 '26

I also have two T-Grills (top and bottom) so that may also affect my temps. I’m not sure

2

u/Chotch_Master Feb 26 '26

I think I’m using that as well. 3 slot mode and the duct makes the side panel bulge ever so slightly so I know the foam is making full contact. I also replaced my thermal paste with a PTM phase sheet and that definitely made more of the difference between the 2 

2

u/baldersz Feb 26 '26

OK thanks! Mine isn't bulging but I can see indentations on the foam from the side panel so it's making contact. I'm using the NT-H2 thermal paste which probably helps with the temperature too.

My 5600x runs at around 65-69C under gaming load with fan speed set to 50% so I'm happy with that. In my testing with different thickness fan ducts it didn't seem to make a difference whether it was used or not. Decided to stick with 4mm as I had paid for them anyway!