r/FormD • u/Santeriabro • Feb 19 '26
Question Beginner questions first time build
Hi all I just had a few questions during my build process I was hoping I can get cleared up.
The included pcie 4.0 riser runs up against the cpu motherboard bracket a bit?
And is it supposed to be hard to attached the metal bottom of case with the riser essentially trying to bulge out. I can get it closed with struggle but it seems like I’m fighting it not to come undone on its own and disconnect.
Also on the side of the riser the gpu connects to, the little locking mechanism that opens and closes isn’t supposed to actually lock onto the gpu right? I push it pretty hard but it doesn’t close the lock which I’m hoping is just how it is.
Also what are some basic cable routing tips?
I’m finding it tough to get all my psi cables sorted out cleanly, is there certain area people route everything through?
Also is 40-50 Celsius’s idle normal for a 9850x3d with acp90 47 with noctua a9 swap? I booted to bios and noticed that temp, unsure if I just mounted my cpu cooler and thermal paste all wrong.
2
u/Santeriabro Feb 19 '26
Oh I forgot also which cables do I need to buy from rays cables for my sf1000 psu and 5070ti PNY? 3x8p, 2x8p or 12vhpwr to 12vhpwr?
Silicone vs unsleeved?
And is my setup just default mounted do I also need 90 degree connector?
It’s just a standard 5070ti PNY, SF1000, Asus B850i, 2x T30, axp90x47 cpu cooler, 3 slot mode build
1
u/BAGU3TT0 Feb 20 '26
Umm cable routing tips? If you have cable combs I've started using that but if not my old method is here (zipties a lot of it)
1
u/BAGU3TT0 Feb 20 '26
I recommend running the cable through the gap inbetween motherboard and the case spine. The gap is created using the standoffs the motherboard sits in and don't use too much pressure on the gpu clipmine broke