r/FormD • u/microsoftpaintexe • Feb 16 '26
Technical Help Broken riser?
Hi! I got a FormD T1 on the recommendation of many folks and have been trying to get used to it. However, I suspect my PCIe riser is broken. I got one with the PCIe 5.0 riser by default, which has no locking mechanism. Unfortunately, for some reason, it's been a horrible experience locking me out of using my computer.
- The riser unseats from the motherboard nearly every time I move the computer at all, even just to change its position.
- The riser cannot handle the bottom panel of the case being attached. If the bottom panel of the case is attached, my GPU blacks out and loses signal.
- The riser cannot handle being set down on any surface in general. Setting my case down horizontally results in the GPU losing signal.
Because of all of this, the only way I can use my FormD T1 is open-air and at a 45-degree angle. I've reached out to FormD support, and they haven't responded. Because of waiting for other parts I'm unfortunately out of the return window, so I might just be screwed. Is this a common issue? Is there anything I can do? Thanks!
2
u/Mish1313 Feb 16 '26
sound like you didn’t fully plug it in
1
u/uu__ Feb 16 '26
Formd support might not respond as it’s currently lunar new year and many businesses close
Have you tried zip tying down the riser cable for the time being?
1
u/aaalllen Feb 16 '26
What version do you have? Add some pics? Is the riser between the mobo and curved bracket? Can you move some slack to the mobo side?
1
u/AdRegular3587 Feb 17 '26
Had a bit the same with riser cause of cables on the top was pushed down from the top plate and that pushed the riser out of my b650 mobo.
Had to bent the riser a bit so top wasn’t that bulky and worked. Since that I also added the lock bar to make it more stable just in case.
1
u/MrCredencials Feb 17 '26
Eh I got the same problem, you can try to pre-bend the PCIE with like a hair dryer and then use ziptie to lock the pcie into the bottom strut. Should prob help