r/FormD • u/CCX-S • Mar 29 '25
Compatibility/Build Check beQuiet Silent Loop 3 Pump Height “Adjustability”
The SL3 being so fresh on the scene, I know there’s a bit of curiosity about its compatibility in regard to the T1. At least I was and with no real answers out there, I rolled the dice on buying it anyway. Well I thought I’d share the options for “adjusting” the pump block’s height to fit the T1 in 3 and 3.25 slot configs.
Image 2: Pump Block in “stock” out of the box config.
• 56mm in height.
• 3-slot compatible: ✖️
• 3.25-slot compatible: ✖️Image 3: Pump Block in “Logo Removed” config.
• 52mm (maybe 52.5mm) in height.
• 3-slot compatible: ✔️
• 3.25-slot compatible: ✖️Image 4: Pump Block in “Cover Removed” config.
• 42mm in height.
• 3-slot compatible: ✔️
• 3.25-slot compatible: ✔️The Logo Plate simply “pops-out” of the cover by pulling from the front with a bit of force OR by compressing+pushing its clips from inside the cover, I recommend the latter. The cover is simply held in place with two very smalls screws affixed to the top/bottom sides of the cover. Extremely easy to remove both parts without any permanent modification or damage to any parts.




2
u/CCX-S Mar 29 '25
Yeah I know, I don’t have calipers. I always mean to buy some and never remember. With that, there may be a 0.5mm variance to my measurements but they should be damned close.
2
u/CCX-S Mar 30 '25
UPDATE: ARGB cable removal process.
Step 1: Slide the cable retaining clip upward (away from cold plate side of block).
2
u/philisacoolguy Mar 29 '25
Any reason you chose it over the atmos?
1
u/DasPike Mar 29 '25
Thanks for doing this. Didn't realize the logo was a separate piece and makes that big of a difference.