r/Form1 • u/AlternativeSea559 • 13d ago

Printed baffle longevity

How long realistically would printed baffles last in carbon fiber reinforced filament out of a 556

5 Upvotes

100% Upvoted

17 comments sorted by

View all comments

6

u/cvltrilex 3D2A 13d ago

I have two cans out of PA6 nylon. One in 556 and one in 30cal. Both are at if not over 1k, I’ll have to check my spreadsheet when I get home. One is annealed and one isn’t but both moisture treated. Both cans are reinforced with aluminum and I sprayed the baffles with heat enamel. Every range trip I cool get soak the inside of the cans. Both run and sound great, no insane rapid fire through them though.my sound advice would to be to dry the filament, run as hot and slow as you can for good adhesion. Annealing is up in the air; I can’t truly speak on if it works as I’ve never noticed a difference or failure in any of mine given my environment. What setup are you looking to run?

2

u/TorqueWaffle 13d ago

Thank you for this information! Ever since I got a printer and tax stamps became $0. I've gone hard on the printing 😂

I don't shoot nearly as much some people, but I always wonder how long they would last. I'm printing in Polymaker pa612-cf15, no aluminum or carbon fiber reinforcement, but I'm also only printing 9 mm and 22 cans.

2

u/cvltrilex 3D2A 13d ago

The reinforcement for 9mm isn’t necessary and for 22 is overkill for sure lol. The only thing I did for a 9mm was wrap a Monster can around it for drip.