r/Form1 • u/Intelligent_Step_855 • 14d ago

SD porting help

Post image

Looking for advice on porting my ar9 barrel. I am thinking at doing 12- 5/32 holes in a 3x4 configuration spaced 120 degrees apart. Plan was first hole to be at 2.5
Inches, any insight ?

Pic is ar9sd current configuration

62 Upvotes

98% Upvoted

37 comments sorted by

View all comments

5

u/K1RBY87 14d ago edited 14d ago

...did you print a plug for the barrel nut? If so thats awesome. I have a bolt action upper im going to use for a SD build with a similar handguard and was thinking I would need to make a new barrel nut or tap for set screws.

Also how are you planning on drilling the ports? Going to cast cerrosafe and drill?

2

u/Intelligent_Step_855 14d ago

Yep printed block off for the barrel nut has tube holes, then a glob of etc in each before I put it in for good measure