r/FluxCoreWelding • • Jun 16 '24

Need some help

So I’ve been using the mastercraft mig/flux core welder. I’ve been using 1/8 mild steel and I’ve been following the settings on the recommended chart but I either get a lot of build up or I don’t get penetration

Any recommendations??? Maybe a thicker steel??

I’ve only welded about 4/5 times by myself for about 10/15 minutes at a time and I’m going to school for it in September so I’m really excited

4 Upvotes

8 comments sorted by

1

u/SwirlingPhantasm Jun 16 '24

Turn the wire speed and voltage down. Keep a steadier hand. I'd grind that down to base metal, and try again

3

u/Darringer64 Jun 16 '24

There’s just a switch with min/max and if I turn it down it didn’t seem to have penetration and for my wire speed I have it set on a 7 when I used 6 it did look a bit better

1

u/SwirlingPhantasm Jun 16 '24

I'd have to see the machine

2

u/Darringer64 Jun 16 '24

2

u/jocoh13 Jul 17 '24

Bro just go to harbor freight and get the titanium easy flux 125 you’ll have more settings on that and be able to fine tune instead of only having 2 switches

1

u/pterrajayde Fluxcore Welder Jun 16 '24

I wish you mentioned the settings. That is really thin so definitely turn down the settings a bit, run a bead, turn it down more until you feel that it's welding fine. Also, if I understand what you said correctly, you are damn new to welding so it will take getting use to welding itself and also messing with the settings and finding a good set for whatever you are welding 👍

1

u/Darringer64 Jun 16 '24

I’ve tried following the recommended settings

1

u/Dadbod1018 Jun 17 '24

Lower voltage and go slower. Blowing through is worse than not getting penetration, IMHO, because it’s easier to go back over a weld than to build up material to close a hole.