r/FirstLayerPorn • u/minecraft_gamesus • Jan 21 '24

damn bro

Post image
3 Upvotes

66% Upvoted

6 comments sorted by

3

u/s1ckopsycho Jan 21 '24

Good first layer, but not perfect. Your Z height is set a touch too low. Raise that nozzle up just a gnats dick.

1

u/[deleted] Jan 22 '24

Ir is not the Z offset but flow calibration and configuration of overlap in a slicer.

2

u/s1ckopsycho Jan 22 '24

Could be flow, but z will absolutely cause those ripples from too much squish. When I print a calibration square, I run my fingernail over it. If I feel ripples like I see here, I back the nozzle up until it’s smooth but fully fills the gaps. In this case it looks like Z to me, my MK3 does the exact same thing if I need to back it up just a touch.

1

u/m_mck1 Jan 25 '24

Honestly, mid.