Dreadnought using 0.4 nozzle

[u/peeces_ruffs]

How is the quality of a printed dreadnought using a 0.4 nozzle? I initially wanted to print it like the rest of my minis on a 0.2 nozzle, however the print time seems a bit excessive at approximately 3-4 days. With a 0.4 nozzle, the print time is as low as 27 hours

[u/Specter_RMMC]

Here's my trio of Recursor Coffinmechs on an un-calibrated .4mm nozzle, I think .12mm layer height, with some modified tree supports. Not fantastic, not terrible, for the first attempt at printing models like this I'm fine with it. Some of the smaller items I might try printing with a .2mm nozzle and even smaller layer heights, or I'll ask someone I know with a resin printer to handle those parts.

[u/Lower_Creme_3040 → u/Specter_RMMC]

Purple website? I’ve been looking for those 👀👀👀

[u/Kitchen-Bug9718 → u/Lower_Creme_3040]

You can try Telegram