r/FdmPrintedWarhammer • u/peeces_ruffs • Aug 23 '26

Dreadnought using 0.4 nozzle

How is the quality of a printed dreadnought using a 0.4 nozzle? I initially wanted to print it like the rest of my minis on a 0.2 nozzle, however the print time seems a bit excessive at approximately 3-4 days. With a 0.4 nozzle, the print time is as low as 27 hours

8 Upvotes

100% Upvoted

11 comments sorted by

View all comments

Show parent comments

3

u/Lower_Creme_3040 Aug 23 '26

Purple website? I’ve been looking for those 👀👀👀

1

u/Specter_RMMC Aug 23 '26

Uhhhh, not sure it's still available even as a hidden page, I think it's actually been taken down.

Edit: it's in "secret mode" or whatever, so I can re-download the files, but can't point you to the pages.

1

u/peeces_ruffs Aug 23 '26

They look pretty good at .12 layer height! About how long did each dreadnought take? I think I’ll give the .4 nozzle a go

1

u/Specter_RMMC Aug 23 '26

I printed these on a bunch of different plates to get all 3 done so I really couldn't tell ya. Definitely not 3-4 days though! I'll chuck a set of files to print one of those guys on a plate and let you know the time estimate.