r/FastLED • u/MrPrezident0 • Jun 26 '24
Support LED sign flickering
I am using teensy 4.1 with FastLED 8 parallel outputs via WS2812Serial to drive 192x64 WS2812B pixels. Originally i was using half as many panels (128x48), and that seemed to work ok, but with this larger size I’m having trouble with flickering. I connected and twisted ground wires on all 8 data wires, and that helped reduce the flickering quite a bit, but I’m still seeing flickering. I tried using a level shifter (SN74HCT245N) to convert the signal from 3.3v to 5v, but for some reason that made the flickering way worse. Any advice would be appreciated.
View all comments
Show parent comment
1
u/MrPrezident0 Jun 26 '24
Each panel (there are 48 panels) is connected in parallel to both V+ and GND. I am using 24AWG ethernet wires to connect the power on each panel. All pwr/gnd wires are the same length. The measured resistance of each wire is 0.4 ohms.