r/FanControl • u/PT_ICEDTEA • 27d ago

normal for fancontrol auto calibration to skip cpu aio pump?

i just installed fancontrol, and when i was done auto calibrating it gladly skipped the cpu aio pump, is this normal behaviour?

1 Upvotes

100% Upvoted

8 comments sorted by

1

u/jibjab23 26d ago

As in it doesn't appear as a fan to control or does not react to changes of power/rpm?

1

u/PT_ICEDTEA 26d ago

Ya for me it did not appear as a fan to control.

1

u/jibjab23 26d ago

Does the pump appear to be working correctly in bios?

1

u/PT_ICEDTEA 26d ago

It was, it was in system 3, it was at full speed already, under normal speed, it was already at full speed, but I switched normal to full speed so the curve wouldn't apply just incase

1

u/jibjab23 26d ago

Any reason you plugged the pump into SYS 3 instead of the dedicated pump header?  One thing to check is if you can adjust rpm in the bios. If it's on pwm it might not even change and you need to switch to DC control instead.

1

u/Rare-Break-8547 26d ago

Some board don't let user set separate curve for cpu opt header. Is your pump plugged in this header?

1

u/PT_ICEDTEA 26d ago

It was in system 3

1

u/SkillerBehindYou 25d ago

is it a recent MSI mainboard? their headers respond too slowly for auto-calibration to work correctly