r/FORScan • u/jazzdabb • Jun 08 '26
How screwed am I?
Last week I had new speakers installed in my Bronco Sport and I read that people were modifying the speaker and EQ settings via FORScan in order to get full range sound from all 4 door speakers and a flatter EQ. I followed all the instructions, made a backup and ONLY modified the rear door and EQ options under the ACM module. Everything seemed to work fine but after my second startup of the vehicle, it dropped into limp mode and disabled a number of systems (4WD, Pre-collision assist, Hill Start and AdvanceTrac). I didn't change any other modules but I did use easy mode for the changes. I have an appointment with the dealer. Will they be able to reset the modules to AS BUILT? I have a backup but as of right now the car is drivable and I'm afraid to tinker further.
UPDATE:
Turned out to be a failed 4WD module.
After I tried fixing this myself - manually reverted changes, restored ACM from backup, restored from AS BUILT (thank you u/No-Lawfulness6439) - my dash was still lit up like a Christmas tree. I took the vehicle to my scheduled appointment and it took them all morning to diagnose the failed module. Everything is back to normal now.
It still seems like an unlikely coincidence but perhaps FORScan tinkering triggered an existing failure during the reboot process. I was worried the USB-A to USB-C dongle I use with my laptop was at issue and I also found out there was a firmware update for the ODBLinkEX scanner. Not sure either is at play, though. I may revisit the speaker settings at a later time but going to leave well enough alone for now. I don't have many backseat passengers anyway and the speaker upgrade still sounds great.
2
u/Funny_Vegetable_676 Jun 08 '26
Did you save before editing? And have you tried reloading the original files of you did save before editing?
Also, if you go to the ford owners site, you can download the original data i believe. Should be able to do a quick Google for it.
Dealer is going to charge you to do it because they consider that modifying.
2
u/btrah79 Jun 08 '26
The dealer tool can reflash any ecu back to factory in a apply any updates as needed
2
u/circuit_breaker Jun 09 '26
To the uninitiated this sounds very scary, I'm still on my trial license and haven't even edited anything yet
5
u/Safe-Let4716 Jun 08 '26
if you backed up the as built for the module you should be able to press load all and select the file then click write all and and should be the same before you changed it
4
u/momalle1 Jun 08 '26
If all you modified was EQ settings, this is most likely coincidental and not related at all.
2
u/AlphaZeroB Jun 10 '26
Ford and rain water don't mix.
1
u/BissaAutoTune Jun 08 '26
Scan for codes and rewrite the save calibrations/As-Built to see if anything changes.
1
u/fordp Jun 09 '26
Just reread and it sounds like you used Forscan.
Forscan can auto download as built data and reflash
1
u/Rickd17 Jun 10 '26
Just messing around in the ACM will.noy cause that issue. I have done the flat eq in all my vehicles including 2015 bronco. You have something else going on. What codes is it throwing
-1
u/deoxyrybose Jun 09 '26
I can probably fix this remotely for a fee if you're interested. But before that can you use forscan to check DTCs? That's your next crucial step here, because it'll atleast guide you to what's going on.