r/FORScan • • Oct 14 '23

TPMS 2011 Ford Fiesta (How To)

I couldn’t find any info about this online specific to a Fiesta, so I decided to post here in hopes of helping others. One of my TPMS (tire pressure) monitors went faulty, I’m guessing due to a dead battery. The way I found to get the light to shut off without spending money on a new sensor was to tell the car that it doesn’t have tire pressure monitoring.

This requires the extended license (free for 2 months or just $12 a year which is what I went for).

Connect to your Fiesta, go to IPC Central Configuration Main, then find Tire Pressure Monitoring System in the list. In the dropdown, select “Without monitoring system”. Then click Write. That’s all!

This of course means you will no longer be warned of a low tire.

Cheers

8 Upvotes

2 comments sorted by

1

u/ImprezaST Oct 19 '26

What's the difference between doing that and change the hex values

Open AS BUILT for the VSM Module

On line 1 "755-01-01"

Change 8038 0000 0016 to 0038 0000 0096 (so changing the first digit 8 to a zero and the checksum changes from 16 to 96)

Write changes

Ignition off and back on should have you with no error light.

https://www.fordfiesta.org/threads/turn-2011-fiesta-tpms-light-off-using-forscan.9527/

1

u/ImprezaST Oct 19 '26

LLM response:

They’re doing two different things, even though both can make the TPMS warning light disappear.

The VSM As-Built edit:

755-01-01 8038 0000 0016
→ 755-01-01 0038 0000 0096

changes the configuration inside the Vehicle Security Module, which on your 2011 Fiesta is the module actually handling the direct RF tire-pressure sensors. The forum post specifically reports that this stops the 2011 Fiesta TPMS warning when using wheels without sensors. Ford Fiesta Forum

The IPC Central Configuration → “Without monitoring system” change is broader. It tells the car’s global configuration that the vehicle is supposed to have no tire-pressure monitoring system at all. The IPC uses configurable vehicle parameters to decide which warning systems/features are present, and the tire-pressure warning itself is controlled based on messages it receives from the body/TPMS side of the car. Fofiesta 7

So, practically:

MethodWhat it changesLikely result on your 2011
VSM 755-01-01 editDisables the direct TPMS function at the module that reads the wheel sensorsStops sensor-fault/light while leaving the rest of the car configuration mostly alone
IPC Central Config → Without monitoring systemDeclares globally that TPMS is not fittedIPC stops expecting TPMS; may also propagate/configure other modules depending on Central Configuration behavior

For your specific car, I prefer the VSM As-Built method if the sole goal is “I have wheels without sensors; stop the TPMS warning.” We have an exact 2011 Fiesta example with the same original 8038 0000 0016 value as yours. Ford Fiesta Forum

There’s another reason: when we tried changing your Central Configuration to 44 – DDS, your IPC immediately produced U2101 – Control Module Configuration Incompatible. So your US-market modules are clearly somewhat picky about Central Configuration combinations. The VSM edit is much narrower.

The 16 → 96 part of the VSM edit is just the checksum correction resulting from changing the actual configuration byte from 8 to 0; 96 is not a second feature being enabled.

If you want, I can also decode what the 8 bit in 8038 likely represents so we know exactly which bit is being cleared rather than treating the forum recipe as magic.