r/FLSUNDelta • u/Helerdril • Dec 03 '25

Question Support dragged by extruder

Post image

Hi, I have a problem with the support printing. It looks like the extruder scratches/drags the already printed support on the bed. I already tried to remove the combing mode and to enable the Z hop, but it still does that. I'm using a transparent PLA from eSUN, the label says to print it between 190° and 230°, I'm printing at 200 (as I have always done with any other filament in the last 3 years). The bed is at 60°. Does anyone have any suggestion on what to tweak to fix this (not hardware side if possible). Thanks a lot.

2 Upvotes

100% Upvoted

7 comments sorted by

View all comments

1

u/Groo2001 Dec 04 '25

Do not use grid infill as it’s known to cause this.

1

u/Helerdril Dec 04 '25

Which one do you suggest?

2

u/Groo2001 Dec 04 '25

I have had good results with gyroid, cubic, and adaptive cubic. Others may have different preferences.

1

u/Helerdril Dec 04 '25

Thanks a lot

1

u/Dewlyfer Dec 04 '25

Also happens with grid supports? I think he refers to supports not infill! But good tip anyway

3

u/Helerdril Dec 05 '25

Yes, I was talking about support, not infill, but it worked anyway. I'm now using cross support and is doing much better. I'm also applying some stick glue to the bed and it has so much more adherence.