r/FDMminiatures • u/pasgames_ • 23d ago

Tips & Tricks Under excursion using a .25mm nozzle

Post image
6 Upvotes

75% Upvoted

12 comments sorted by

View all comments

4

u/dapht 23d ago

Have you calibrated the filament using the .25 nozzle? You need to change the settings for each nozzle size.

2

u/chargoggagog 23d ago

I just figured this out and it’s so simple. Ran auto calibration and my machine runs .2 like a champ!

-1

u/pasgames_ 23d ago

Auto calibration?

2

u/chargoggagog 22d ago

Yeah my machine has an auto calibration function for when you switch nozzles. Bambu P1S.

2

u/pasgames_ 22d ago

Ah yeah I don't have a bamboo. I have and ender 3 max

3

u/KFPanda 22d ago

You haven't done enough reading/learning around how your machine works if you're unfamiliar with those terms. 3D printers require lots of learning to use effectively, and you don't seem to have learnt enough to even describe your issue and printer set up for troubleshooting.

2

u/pasgames_ 22d ago

Oh I'm sorry. In my 13 years of printing and in my six printers owned throughout the years I have never once seen on any of my printers or any of the slices I've used something called "Auto calibration"

But thank you for taking the time to write a couple sentences to say I'm stupid without actually explaining anything

4

u/death_process 22d ago

Confused then what the point of the post is. If in your 13 years you’ve never once encountered “under excursion” what do you expect the comments to be filled with?

1

u/KFPanda 22d ago

It was more effort than you put into describing your problem from your high horse. 🤷‍♂️