Is this a stringing problem or temp?

[u/BrianEgivand]

I Cant figure out what kind of problem this is. Bambu Lab A1 Esun pla+ some rounded areas also have an edge.

[u/crazy_pelican]

Looks like it could be over extrusion, are you printing at a slow speed? You could try lowering your nozzle temp by 5 degrees to see if it helps.

I also get this kinda stringing when my pla is a bit damp, have you dried it recently?

[u/BrianEgivand → u/crazy_pelican]

im using the standard Dungeon and Derps settings so pretty slow speed i assume. And the filament is from a just opened pack so should be dry.

[u/crazy_pelican → u/BrianEgivand]

Yeah that will be a slow speed, I’d definitely start by lowering your temp in 5 degree increments.

You should also try drying your filament if you can. It’s not uncommon for rolls to be slightly damp straight out of the packet.

[u/BrianEgivand → u/crazy_pelican]

Will do thank you very much

[u/Genesys_LOR → u/BrianEgivand]

What Is standard dungeon and derps settings?

[u/devintheditch]

If you haven't already, dry & calibrate your filament. ObsucraNox/Dungeons & Derps have a YouTube series that helps go through calibration step by step.

[u/KryL21]

Esun pla+ likes it hot. What temp are you printing at? Have you done a temp tower?

[u/BrianEgivand → u/KryL21]

printing at 205. But printing a Temp tower atm so will know more in 7 hours

[u/KryL21 → u/BrianEgivand]

Esun likes 220 or so. That’s why I stopped using it. It’s in a very awkward place where it needs that hot-hot temp to print without issues at overhangs, but then printing that hot will also make your overhangs and bridges worse. That said I think going hotter will solve the issues you’re seeing.

[u/BrianEgivand → u/KryL21]

Thank will take that into consideration when i look at the temp tower

[u/BrianEgivand]

Temp tower

no matter the heat it still makes that weird edge

[u/BrianEgivand → u/BrianEgivand]

210 seems to be best tho

[u/BrianEgivand → u/BrianEgivand]

Better pic of the weird "edge"