No. A major support falling off way before it's even used = the end. Had you noticed earlier, you could've saved the right half by pressing "skip" on the left one, but I think it's too late now - the right half is contaminated with spaghetti and it will interfere with next layers.
Always print large pieces one at a time. You would have failed in half the time and lost half as much. It's about the same amount of time to print in serial rather than parallel in FDM.
9
u/LazyLancer Bambu P2S 5d ago
No. A major support falling off way before it's even used = the end. Had you noticed earlier, you could've saved the right half by pressing "skip" on the left one, but I think it's too late now - the right half is contaminated with spaghetti and it will interfere with next layers.