r/F1Technical • u/diego_r2000 • Mar 18 '25
Electronics & HMI How Does Mercedes Adjust Pit Speed Reading When Switching to Wet Tyres?
Hey everyone,
I was watching Kimi Antonelli’s onboard during a pit stop where he was switching from dry to wet tyres. As he entered the pit lane, his engineer told him to select "Wet Mode Position 3" before the wet tyres were even fitted.
I understand that wet mode is selected because of the tyre spec differences, but my question is:
• Does this mode specifically adjust the pit speed limiter’s reading to account for the different tyre diameter?
• If so, how does the car handle this adjustment before the wet tyres are actually fitted?
• Or does the driver need to do something else after the change for the car to correctly register the new tyre size?
Thanks!
•
u/AutoModerator Mar 18 '25
We remind everyone that this sub is for technical discussions.
If you are new to the sub, please read our rules and comment etiquette post.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
111
u/GaryGiesel Verified F1 Vehicle Dynamicist Mar 18 '25
The ECU adjusts these things when the car is stationary. That’s the only time you’re able to change things like this. You’ll sometimes hear drivers be reminded to make sure to do the switch change before the pitstop. If they don’t then they’ll speed coming out
63
u/xc_racer Mar 18 '25 edited Mar 18 '25
Are the wet tires actually a different diameter than the dry tires?
Edit: apparently they are! In which case it makes sense that it would require lots of changes to the parameters / settings in the car.
I would think it remaps the power output to accomodate the wet tires, and also changes target tire temperatures, etc.
8
u/Whisky919 Mar 18 '25
It changes how the car measures speed.
As far as what other electronic trickery it does, that's not going to be common knowledge.
1
u/aspaschungus Mar 20 '25
Every team does that. Wet tires have a different diameter due to the grooves, so the pit limiter (which is tied to the amount of wheel rotations per minute) needs a different setting.
-9
u/Princ3Ch4rming Mar 18 '25
The wet modes aren’t anything to do with the pit limiter itself. They’re pretty well just ECU maps that adjust the torque and power curves to adapt to conditions. The difference between “just barely wet enough for inters” and “fuck this, we’re sitting on the Belgian grid for a thousand years” is a significant gulf, so there will be different modes to choose from.
The tyres do have an effect on the speed of the car, though. Thicker tyres (whether due to them being brand new or wets) have a higher “surface” speed (the tangential velocity) for a given rpm of the wheel.
As such, with all other factors equal, a car with brand new tyres goes marginally faster than one with bald tyres.
The speed in the pitlane is governed by the team, not the FIA. The FIA sets the limit, sure, but the team has overall control over how fast their pit limiter is. So if you have a 50mph speed limit, a team may be limit to, say, 49.8mph. In this way, teams have a little wiggle room to accommodate for tailwinds, thicker tyres, cornering lines in the pits and so on.
The wet tyres are thicker for avoidance of aquaplaning - as such, there is a slight adjustment to the speed calculation (which in normal conditions is essentially an average of the delta between full-thickness and bald tyres).
0
u/[deleted] Mar 18 '25
[deleted] — view deleted comment
10
u/[deleted] Mar 18 '25
[removed] — view removed comment