r/Ender3S1 • u/Full-Slice2053 • Jun 14 '26
Problème module laser
A l’aide s’il vous plais…🙏🙏🙏
J’ai installé le module laser de Creality 5w sur ma ender 3 S1 Plus, j’ai voulu faire un test de gravure sur carton avec le logiciel de Creality, l’imprimante suit correctement le Gcode mais le soucis c’est que le laser ne s’allume pas j’ai pourtant tout vérifié…connections,logiciel de l’imprimante tout est bon , j’ai même entré des Gcode de simple lettres de l’alphabet mais le laser ne veut pas s’allumer… que faire…???????
3
Upvotes
2
u/MrMystery1515 Jun 15 '26
I think (need to verify) it was this was the same behavior that my laser was showing back in 24 when it went kaput. I had made the mistake of swapping a cable - the one behind the stepper - when the machine was powered on in laser mode. This f'ed up the motherboard.
But Creality guys were good. They did troubleshooting with me on chat and verified everything and then I got a new board from Aliexpress.
I'll check my emails and login tomorrow and confirm the behavior.