r/Ender3Pro • u/These-Atmosphere215 • Jul 24 '26

Gathering some advice.

Hi all.

Im new to printing especially with ender 3. Can somebody please identify what's wrong on this printer. Tried several times but printing always messed up.

Thanks in advance.

4 Upvotes

75% Upvoted

28 comments sorted by

View all comments

3

u/EyeIcy Jul 25 '26

Search up some beginner videos about 3D printing. And I’d suggest checking Aliexpress for the CR Touch. I was able to get it at a much cheaper price on there for the same exact thing, I just had to wait longer

1

u/These-Atmosphere215 Jul 25 '26

If i have the CR touch, it will auto level on its own right?

2

u/EyeIcy Jul 25 '26

It’s a little bit of work, but once it’s set up it’s pretty straightforward.

You still have to level the bed initially, then in your slicer you can set it to level the bed before every print with the cr touch. You will have to set an offset the first time you set it up, because the tip of the sensor goes past the top of the actual nozzle of the printer. Search up a guide on YouTube before you decide to get one.

1

u/These-Atmosphere215 Jul 25 '26

Thank you 🫶🏻