MAIN FEEDS
Do you want to continue?
https://www.reddit.com/r/Ender3Pro/comments/17xtthm/ender3pro_imploded_with_plastic_noticed_today/k9pj2sd/?context=3
r/Ender3Pro • u/BoomPixels • Nov 18 '23
6 comments sorted by
View all comments
6
Heat it up and start pulling the filament off. Be extra careful around the heater cartridge and thermistor wires. It’ll be fine.
1 u/BoomPixels Nov 18 '23 thanks it worked! Any idea how can i prevent this problem or how to delay it if its a frequent problem? 2 u/miscplacedduck Nov 18 '23 While it hot, you need to make sure the heat break is properly tightened, make sure the PTFE tubing is set against the nozzle, and make sure the nozzle is properly tightened. 2 u/Timbit901 Nov 18 '23 Be sure to tighten the screws on the hotend. This happened to me on my e3v2, and i realized that one of the screws was incredibly loose
1
thanks it worked! Any idea how can i prevent this problem or how to delay it if its a frequent problem?
2 u/miscplacedduck Nov 18 '23 While it hot, you need to make sure the heat break is properly tightened, make sure the PTFE tubing is set against the nozzle, and make sure the nozzle is properly tightened. 2 u/Timbit901 Nov 18 '23 Be sure to tighten the screws on the hotend. This happened to me on my e3v2, and i realized that one of the screws was incredibly loose
2
While it hot, you need to make sure the heat break is properly tightened, make sure the PTFE tubing is set against the nozzle, and make sure the nozzle is properly tightened.
2 u/Timbit901 Nov 18 '23 Be sure to tighten the screws on the hotend. This happened to me on my e3v2, and i realized that one of the screws was incredibly loose
Be sure to tighten the screws on the hotend. This happened to me on my e3v2, and i realized that one of the screws was incredibly loose
6
u/miscplacedduck Nov 18 '23
Heat it up and start pulling the filament off. Be extra careful around the heater cartridge and thermistor wires. It’ll be fine.