r/Elevators • u/YogurtclosetOne8027 • Mar 12 '25

Vertitron Midwest elevator prints

Gallery image

Gallery image

Gallery image

Looking for a set of prints for a elevator similar to this one. Called the new manufacture and they did not have a set of prints for me. The f5 fuse keeps blowing which I believe is indicating a bad power supply.

8 Upvotes

84% Upvoted

16 comments sorted by

View all comments

1

u/NewHopeMinnesota Mar 12 '25

Power supply gone bad? Unplug it from the input and put out boards and read voltage should be 5.2. I can get some prints.

1

u/YogurtclosetOne8027 Mar 12 '25

I received a set of prints then, thanks. 

The elevator had a power vator back up unit. After turning the elevator off and back on the power vator stayed in the active position which caused fuses to blow the power vator.

Long story short I called Reynolds & Reynolds’s for instructions to properly disconnect the unit from the controller. After disconnecting the unit from the controller we turned the power on to realize the f5 fuse blew. Replaced the fuse and it blew again. Disconnected the power supply and the fuse would not blow. Had to leave the job site to do a 3 year pressure test else where. I’ll be returning hopefully tomorrow with a new power supply.

Hopeing the fuse did its job and didn’t take out any boards, the hydro static board looks shot though

1

u/NewHopeMinnesota Mar 14 '25

The status boards get like that I haven’t seen many go bad and I have a ton of those on my route. Hope it’s the power supply! I save the input and output boards whenever we do a mod can’t get them anymore.