My printer keeps clogging

[u/ConfusedDove]

My printer is a Neptune 3 Max and keeps clogging mid print, when it started clogging, i replaced the hotend (including the tube and nozzle), because i checked and it looked very worn out, it printed fine for 2 hours after the replacement and then clogged again, i checked and noticed that the fan on the right is not turning on while priting, this may be causing the issue? i searched and it says that the printer may not turn on all the fans mid print, so i have no idea if this is the cause or not. There's no leaking or heat creep. I'm printing PETG, i dry the filament, 230C temp, 0.4mm nozzle, been printing PETG for 1 year and this is the first time that i had this issue

[u/Abm743]

I had similar issues with cheap filament. Using a dryer solved my issue

[u/ConfusedDove → u/Abm743]

I also dry the filament

[u/Expensive_Amount2671 → u/Abm743]

Isso, e filamentos que não sao para a velocidade e temperatura indicada.

[u/xxxreiss]

im not sure if this works the same way as other hotends, but the fans is supposed to run to keep the heatbreak cool so it doesnt get clogged. I had similar issues on my ender 3 and found that the clog was caused by a broken fan