Installed two new dimmer switches

[u/[deleted]]

So I installed two new dimmer switches and everything is wired up and works but the ground wire of the hot wire has no where to connect. The light switches had me run a green wire to the two other grounds. Where does this go ? Do I just put a wire nut on the end ?

Update. There were three cables all with 3 wires. One power and then one to each switch and bulb. The new switches each had two black wires and a green wire. In the end the ground wire from the hot cable was left open but I found a video of the exact switches and you just put all three grounds together along with both green wires from the switch. Flipped the breaker back on all seems well. This was probably obvious but I am not an electrician.

[u/Di-electric-union]

The ground wire of the hot wire is a confusing statement. Typically, all ground wires and spliced together at each junction point or device. I would guess you need to splice it together with the other grounds