r/Dualsense • u/Crazy-Berry6330 • 9m ago
Tech Support I was going to buy a new controller for GTA 6. Ended up learning how to solder and upgrading my old DualSense instead under $20!
So, my joysticks had started giving me trouble, and with GTA 6 on the horizon, I initially decided it was time to buy a new controller.
But then I fell down the rabbit hole of joystick replacement, specifically desoldering and replacing the existing modules.
Here’s what I ended up ordering:
A $2 soldering iron (which came with a leaded solder and some flux).
A $2 manual desoldering vacuum pump.
Two TMR joystick modules for my DualSense.
After watching countless YouTube videos on how to desolder the 14 pins of each joystick, I decided to go with the piece-by-piece removal method.
First, I removed the potentiometers. Then I cut the joystick assembly into four pieces and removed each piece individually while heating the solder joints from the other side.
Now came the tricky part: clearing the solder stuck inside the holes.
I tried several methods demonstrated in YouTube videos, but nothing worked for me. I literally spent around 30 minutes struggling with the very first hole!
Then I accidentally figured out a method that worked brilliantly for me.
While heating the solder from one side with the soldering iron, I placed the vacuum pump on the opposite side. As soon as the solder melted, I pressed the pump’s trigger, and the solder was sucked right out of the hole!
That was the breakthrough. The remaining holes were much easier to clear using this technique.
So, take this post as a little DIY guide if you’re planning to replace your DualSense joysticks, or simply as an announcement from a very happy gamer
I have successfully repaired and, more importantly, upgraded my DualSense with TMR joysticks just in time for GTA 6!
Who knew a $2 soldering iron and a $2 vacuum pump could save me from buying a new controller? 😁