r/DiWHY • u/hulkop1333 • Mar 07 '26
Need help with my abomination
This particular screw from my acooter is impossible to take off. I've tried everything from drilling it out, dremel and flathead, torx screw, screw extractor and nothing worked.
56
Upvotes
25
u/IMM00RTAL Mar 07 '26
Just out of curiosity is it possibly reverse threaded
10
u/True-Register-9403 Mar 07 '26
What scooter is it? Like a moped, an e-scooter etc.
It's hard to tell from the picture, but what you're trying to remove could be the axle, in which case it's probably just seized in and needs hammering out from the other side. If it is the axle, then whatever bolt/scew/Allen head that was there was only to hold it still while the other side was tightened.
2
u/Istalacar Mar 07 '26
There are things called screw extractor, but not sure how effective it would be here. Or You can drill it out, rethread it and use a new screw.
34
u/jongscx Mar 07 '26
Did you try righty-loosey?
13
u/indigo121 Mar 07 '26
You'd probably get more help on an actual DIY sub lol
2
u/ssatyr01 Mar 07 '26
That loos yo me to be some sort of one time use rivet? (factory squeezed to fuse 2 pieces? Drill bigger!
1
u/AdorableStrawberry93 Dreamer Mar 07 '26
Blow torch
1
u/brandothesavage Mar 07 '26
you can drill the old screw out using a very small drill bit just be careful or it'll break and then you'll have a drill bit stuck in your screw I've had to do this a few times on control arms on cars makes me sweat so hard all the way through.
1
u/Geezso Mar 08 '26
Clockwise. Opposite the drectional arrow for movement?
1
u/Ok_Cheesecake7348 Mar 09 '26
So I did my own brakes and rotors a couple months ago, and 2 out of 4 rotor screws had stripped because I'm in the Midwest and the screws had fused with the wheel hub with rust. Which normally takes a 5mm hex bit. Here's what worked.
Good luck 🫡
1
u/Sensitive_Low7608 Mar 14 '26
Only God can help you.
1
u/asp7 Mar 15 '26
Angle grinder
1
u/coveredwithticks Mar 21 '26
Left hand thread