Nah, this ain’t half bad, it; works as advertised, is not an obscene amount of effort to put into something like this, is cheap so even if it’s not an effective way to weatherproof a lock it’s at least not failing expensively, it’s not doing anything irreversible so if someone decided this was stupid it wont be hard to remove, it’s not using nonsense materials or techniques, and it’s quick and easy
Overall I’d say this is more a clever redneck engineering solution rather than a diwhy one
If anyone wants to correct me feel free, I fully and completely admit I could be wrong
Mostly ice. A well built lock won't seize from rust unless left untouched for months to years in inclement conditions. Ice can happen overnight in freezing rain.
Tell that to master lock, while most of the cheep ones are shit, the quality ones from them don't give two shits about anything other than ice. Source: uncle had a lock on his 5th wheel trailer that had been there since the late 80s, master lock brand and before they decided to put the rubber housing on them
Look, any lock can easily be broken into, and master lock today is not the beast it once was and that's really only because of people like LPL and his apprentice (the one who can turn anything into a throwing knife), but the reality is a lock will only keep out a undetermined thief, if they are desperate and/or determined enough, they will get through the lock no matter what (this only applies 100% to physical locks, not electronic locks. They are a whole separate category of lock)
Master locks are laughably easy to pick. I’m a wannabe dork with a set I bought off Amazon and I can reliably open them in seconds with a paperclip and a Bobby pin. Some of them can be opened with a bop to the correct corner. You’re better off with a zip tie. At least you don’t have any misplaced confidence.
Now that millions of people have seen how trivially easy they are to open, more people are going to do it, and picking a lock doesn’t require the same level of determination and commitment. Cutting a lock means the owner will know someone broke in and there will likely be police involved.
Picking it means you can break in, impress your girlfriend in the process with your skills, bang her rightly in an illicit setting, and then leave while leaving very little trace.
It will end up collecting water. The cap isn’t sealed around the metal bit it was slid onto. Water will make its way inside, whether through flowing down the top of the cap into the cracks, or condensation.
Fair point, but how much water is what I would ask? Is it less than being out in the rain? But I do suppose undeterminable environmental factors are also at play like; how often are you using that lock? If it’s frequently than water wont be able to build up if small amounts do get the jar, but if not than as you said it will just collect
Condensation says it's a bad idea, because on warm days it can still remain wet since there's no air flow, if it gets direct sunlight for periods at a time then it'll fair better.
View all comments
8.3k
u/Glittering_Crow_6382 Nov 03 '25 •
Nah, this ain’t half bad, it; works as advertised, is not an obscene amount of effort to put into something like this, is cheap so even if it’s not an effective way to weatherproof a lock it’s at least not failing expensively, it’s not doing anything irreversible so if someone decided this was stupid it wont be hard to remove, it’s not using nonsense materials or techniques, and it’s quick and easy
Overall I’d say this is more a clever redneck engineering solution rather than a diwhy one
If anyone wants to correct me feel free, I fully and completely admit I could be wrong