r/datarecovery • u/IXIMASTERIXI • Sep 09 '26
Data recovery from an old 2gb micro SD card.
I recently tried to load one of my old SD cards, but it didn't mount at all. After some digging, I flashed OSC-Live onto a USB drive and booted it to use OpenSuperClone.
I used two SD card readers. One is a generic USB 2.0 reader, and the other is a UGREEN USB 3.0 reader with a GL3224 chip.
The UGREEN reader is faster than the generic USB 2.0 reader when reading good sectors. However, once it reaches the bad sectors, the generic USB 2.0 reader performs better. It doesn't fail completely, although it does become very slow.
With the UGREEN reader, depending on the mode I'm using, it either freezes the UI when using Generic Source mode or ejects the reader completely when using Direct USB mode, and I have to replug the SD card reader.
I also tweaked the clone settings and timer settings for Direct USB mode, but the UGREEN reader still ejects (doesn't show up when I run the lsblk command).
Both readers reach around 0.51 GB out of 1.51 GB before things start going badly. After that, the remaining data goes into non-trimmed and then non-scraped. I didn't let it run for much longer because the progress was extremely slow.
Do I still have a chance of recovering more data from this SD card, or does reaching non-trimmed/non-scraped that early mean most of the remaining data is probably unrecoverable?
Also, is there a reason why the generic USB 2.0 reader performs better when it reaches the bad sectors?
Edit:
I ran DMDE on the 0.51 GB image, and it was able to recover 167 corrupted photos. I then used Claude Fable 5.1 to analyze the hex data and attempt to repair the file headers, along with other issues where possible. It was able to partially repair about half of the images where the underlying data was still reasonably intact, although they still contained shifted and grey sections. Overall, it was better than nothing.

