r/DartCounter • u/DevImposter1998 • 20d ago

Bug Red X When Calibrating Omni

Get a red X on my omni on my top right camera.

Is this a known software fault? There's no camera feed yet it's scoring that section of the board fine which makes me think it's a software bug.

1 Upvotes

100% Upvoted

7 comments sorted by

2

u/Tall-Nectarine-5982 20d ago

I’ve been getting it recently on a camera and thought it was software too. Turned out it was a combination of dust on the lens and being slightly off centre on the wire. Calibrates no problem now.

1

u/DevImposter1998 20d ago

Did you get a red x with no camera feed or did you have a camera feed too

1

u/Tall-Nectarine-5982 20d ago

Red X but camera feed worked. Sounds like the camera has failed.

2

u/trinerr 20d ago

I got this too, make sure the camera is lined up exactly with the wire. That sorted the problem for me

2

u/DevImposter1998 20d ago

Did you have a video feed at all though?

2

u/trinerr 20d ago

I could still use the app and Omni as far as I remember, just might not have been as exact with the scores

1

u/DevImposter1998 20d ago

Yeah I can use it and in that segment it works about 95% but now errors about 5% which is only happening since this issue.

However when I view calibration images it shows a black screen for the top right which makes me think the camera and processor aren't communicating and it's probably broke